Tuesday, January 11, 2022

How To Make Car Rear Disc Brake In Factory- Disc Brake Making Process ||

6 comments:

  1. Replies
    1. I saw that too. At the beginning it looked like a disc brake rotor.

      Delete
  2. OHSA would have a field day. Open toed flip flops even.

    ReplyDelete
  3. I saw both discs and drums. Not sure where that was, but I would have questions as to the quality and consistency of the steel and accuracy of the hole placement for the wheel studs. I suspect the overall dimensional tolerances were also pretty loose, but then again I'm an old QA guy.

    ReplyDelete
    Replies
    1. Quality of the steel is highly suspect. Black paint here could cover up a multitude of sins.

      Delete